Software Setup

Download and Install

Download and install the software on your computer, this should only take a couple of minutes.
Some hardware (e.g. some cameras) may require additional drivers, you probably already have them installed on your computer if you have used the hardware before (e.g. with the demo software that comes with the camera).
The software will guide you through the installation process for known hardware.

Create a new hardware profile

When you first start the software, you will be asked to create a new hardware profile.
You will be guided through the process of setting up the projector and the camera(s)

Calibration

No-calibration mode

The software can work in a no-calibration mode. This actually means that the calibration will be performed automatically on the onbject without the calibration target. This is usually less accurate and lenght scales will be wrong, but it is useful for quick scans nevertheless.

Your first scan